ProLiant DL320 Server Maintenance and Service Guide

Removal and Replacement Procedures
2-26 Compaq ProLiant 320 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: DarkStar-T Part Number: 203834-003 Last Saved On: 12/28/01 9:29 AM
User Interface Board
To remove the user interface board:
1. Power down the server. See “Powering Down the Server” in this chapter.
2. Remove the access panel. See “Access Panel” in this chapter.
3. Remove the shipping/ejector key. See “Shipping/Ejector Key” in this chapter.
4. Remove the CD-ROM (DVD-ROM)/diskette drive assembly or bezel blank. See “CD-
ROM/Diskette Drive Assembly,” or “DVD-ROM/Diskette Drive Assembly” or “Bezel
Blank” in this chapter.
5. Remove the CD-ROM (DVD-ROM)/diskette drive assembly backplane. See “CD-ROM
(DVD-ROM)/Diskette Drive Assembly Backplane” in this chapter.
6. Slide the user interface board toward the rear of the server and lift to remove the board.
IMPORTANT: Remove the user interface board carefully to avoid damaging the light pipes.
Figure 2-20: Removing the user interface board
Reverse steps 1 through 6 to replace the user interface board.