ProLiant DL320 Server Maintenance and Service Guide

Removal and Replacement Procedures

Compaq ProLiant 320 Server Maintenance and Service Guide 2-25

COMPAQ CONFIDENTIAL Codename: DarkStar-T Part Number: 203834-003 Last Saved On: 12/28/01 9:29 AM

CD-ROM (DVD-ROM)/Diskette Drive Assembly Backplane

To remove the CD-ROM (DVD-ROM)/diskette drive assembly backplane:

1. Power down the server. See “Powering Down the Server” in this chapter.

2. Remove the access panel. See “Server Access Panel” in this chapter.

3. Remove the shipping/ejector key. See “Shipping/Ejector Key” in this chapter.

4. Remove the CD-ROM (DVD-ROM)/diskette drive assembly or bezel blank. See “CD-

ROM/Diskette Drive Assembly,” or “DVD-ROM/Diskette Drive Assembly” or “Bezel

Blank” in this chapter.

5. Disconnect the CD-ROM (DVD-ROM)/diskette drive assembly cable from the CD-ROM

(DVD-ROM)/diskette drive assembly backplane

6. Carefully pull back and hold the plastic retaining clip

7. Lift the backplane vertically until it unseats from the drive bracket and user interface

board

Figure 2-19: Removing a CD-ROM (DVD-ROM)/diskette drive

assembly backplane from the chassis (center wall removed for

clarity)

Reverse steps 1 through 7 to replace the CD-ROM (DVD-ROM)/diskette drive assembly

backplane.