ProLiant DL320 Server Maintenance and Service Guide

Removal and Replacement Procedures
Compaq ProLiant 320 Server Maintenance and Service Guide 2-23
COMPAQ CONFIDENTIAL Codename: DarkStar-T Part Number: 203834-003 Last Saved On: 12/28/01 9:29 AM
Single Channel Wide Ultra2 SCSI Controller Module
To remove the SCSI module:
1. Power down the server. See “Powering Down the Server” in this chapter.
2. Remove the access panel. See “Access Panel” in this chapter.
CAUTION: Prevent damage to the connector pins by lifting the SCSI module evenly and with
equal pressure on the board. Tilting the board causes the connector pins to bend.
3. Remove the SCSI module by pinching the tops of the support posts and carefully
lifting the SCSI module from the system board
.
4. Disconnect the SCSI cable from the SCSI controller connector on the module
.
3
2
1
Figure 2-17: Removing the SCSI module from the system board
To replace the SCSI module, reverse steps 1 through 4, ensuring that the SCSI module seats
securely on the support posts.