ProLiant DL320 Server Maintenance and Service Guide

Removal and Replacement Procedures
Compaq ProLiant 320 Server Maintenance and Service Guide 2-19
COMPAQ CONFIDENTIAL Codename: DarkStar-T Part Number: 203834-003 Last Saved On: 12/28/01 9:29 AM
1
2
2
Figure 2-13: Removing the bezel from the chassis
Reverse steps 1 through 5 to replace the bezel. When the bottom of the bezel is hooked
securely in place, the bezel top snaps into the chassis tabs.
Hard Drive Overview
The ProLiant DL320 server contains two drive bays for either ATA or SCSI hard drives. The
server ships standard with two 1-inch drive trays. The following sections provide general
guidelines and installation procedures for installing or upgrading hard drives.
Guidelines for ATA Hard Drives
When installing ATA hard drives in your ProLiant DL320 server, observe the following
general guidelines:
• Populate hard drive bays starting with the lowest ATA Device number. Device 0 serves
as the primary boot drive.
• Set the jumpers on both ATA drives to Cable-Select mode.
IMPORTANT: ATA hard drives must be configured to the Cable-Select mode.
NOTE: In Compaq ProLiant DL320 servers, ATA drives are set to Cable-Select mode by default.
NOTE: Refer to the documentation shipped with your hard drive to determine how to set the jumpers
on your ATA hard drives to Cable-Select mode, if they are not already set in Cable-Select mode.