ProLiant DL320 Server Maintenance and Service Guide

Removal and Replacement Procedures
Compaq ProLiant 320 Server Maintenance and Service Guide 2-15
COMPAQ CONFIDENTIAL Codename: DarkStar-T Part Number: 203834-003 Last Saved On: 12/28/01 9:29 AM
DVD-ROM/Diskette Drive Assembly
To remove the DVD-ROM/diskette drive assembly:
1. Power down the server. See “Powering Down the Server” in this chapter.
2. Remove the shipping/ejector key from the chassis if you have not already done so. See
“Shipping/Ejector Key” in this chapter.
3. Insert the shipping/ejector key approximately 1.25 cm (0.5 inch) into the
DVD-ROM/diskette drive assembly ejector port on the lower right corner of the server
front panel
to eject the DVD-ROM/diskette drive assembly .
1
2
Figure 2-9: Ejecting the DVD-ROM/diskette drive assembly
CAUTION: To reduce the risk of thermal damage, do not operate the server without either
the DVD-ROM/diskette drive assembly or the bezel blank installed.
To replace the assembly, slide the assembly into the bay until it is fully seated.