HP ProLiant DL320 G6 Server Maintenance and Service Guide

Removal and replacement procedures 57

Install the heatsink.

6. Install the air baffle ("Air baffle" on page 28).

7. Install the access panel ("Access panel" on page 27).

System board

To remove the component:

1. Power down the server (on page 25).

2. Remove the server from the rack (on page 26).

3. Remove the access panel ("Access panel" on page 27).

4. Remove the air baffle ("Air baffle" on page 28).

5. Remove the PCI riser board assembly ("PCI riser board assembly" on page 42).

6. Remove all DIMMs ("DIMMs" on page 49).

7. Disconnect all cables from the system board.

8. Remove the dedicated iLO connector module, if installed ("Dedicated iLO 2 connector module" on

page 49).

9. Remove the heatsink ("Heatsink" on page 50).