HP ProLiant DL320 G6 Server Maintenance and Service Guide

Removal and replacement procedures 29
To remove the component:
1. Determine how many hot-plug power supplies are installed:
o If only one hot-plug power supply is installed, power down the server (on page 25).
o If more than one hot-plug power supply is installed, continue with the next step.
2. Disconnect the power cord from the source.
3. Remove the power cord from the power supply.
4. Remove the power supply from the server.
WARNING: To reduce the risk of electric shock or damage to the equipment, do not connect the
power cord to the power supply until the power supply is installed.
To replace the component:
1. Install the power supply.
2. Connect the power cord to the power supply.
3. Connect the power cord to the power source.
Redundant hot-plug power supply cage