ProLiant DL320 Generation 3 Server User Guide
Table Of Contents
- HP ProLiant DL320 Generation 3 Server User Guide
- Notice
- Contents
- Server component identification
- Server operations
- Powering up the server
- Powering down the server
- Preparation procedures
- Extending the server from the rack
- Removing the access panel
- Installing the access panel
- Removing the PCI riser board assembly
- Installing PCI riser board assembly
- Removing the hot-plug SATA backplane
- Removing the fan assembly
- Installing the fan assembly
- Server setup
- Hardware options installation
- Server cabling
- Server software and configuration utilities
- Battery replacement
- Troubleshooting
- Electrostatic discharge
- Regulatory compliance notices
- Regulatory compliance identification numbers
- Federal Communications Commission notice
- Declaration of conformity for products marked with the FCC logo, United States only
- Modifications
- Cables
- Mouse compliance statement
- Canadian notice (Avis Canadien)
- European Union regulatory notice
- Japanese notice
- BSMI notice
- Korean notice A&B
- Laser compliance
- Battery replacement notice
- Taiwan battery recycling notice
- Power cord statement for Japan
- Server specifications
- Technical support
- Acronyms and abbreviations
- Index
36 HP ProLiant DL320 Generation 3 Server User Guide
Two methods are available to install an OS on the server:
• SmartStart assisted installation—Insert the SmartStart CD into the CD-ROM
drive and reboot the server.
NOTE: The SmartStart assisted installation is available only when a
PCI-based SCSI controller is installed. This feature is not available
when configuring drives with the embedded SATA controller.
• Manual installation—Insert the OS CD into the CD-ROM drive and reboot
the server. This process may require you to obtain additional drivers from the
HP website (http://www.hp.com/support
).
Follow the on-screen instructions to begin the installation process.
NOTE: For SATA RAID configuration, a driver diskette must be
created.
For information on using these installation paths, refer to the SmartStart
installation poster in the HP ProLiant Essentials Foundation Pack, included with
the server.
Registering the server
To register a server, refer to the registration card in the HP ProLiant Essentials
Foundation Pack or the HP Registration website (http://register.hp.com
).