HP ProLiant DL185 Generation 5 Server Software Configuration Guide

System BIOS configuration 14

Table

SuperIO Configuration submenu fields

Option

Description

2E8/IRQ3 Set this value to allow the serial port to use 2E8 as its I/O port address and IRQ 3 for the

interrupt address. If the system will not use a serial device, it is best to set this port to

Disabled.

2F8/IRQ3 Set this value to allow the serial port to use 2F8 as its I/O port address and IRQ 3 for the

interrupt address. If the system will not use a serial device, it is best to set this port to Disabled

S-ATA Configuration submenu

Figure 9 S-ATA Configuration submenu

Table 8 S-ATA Configuration submenu fields

Field Description Options

HT1000 S-ATA Set this value to enable the on-board HT1000 S-ATA controller Enabled

Set this value to disable the on-board HT1000 S-ATA controller. Disabled

S-ATA mode Set this value to S-ATA mode S-ATA

Set this value to P-ATA mode P-ATA

INT13 Support Set this value to enable INT13 support Enabled

Set this value to disable INT13 support Disabled