HP ProLiant DL180 Server Software Configuration Guide

Contents 60
2.
Press Enter to start the installation.
3. At the CD Found dialog box, click Skip. The Welcome to Red Hat Enterprise Linux page
displays.
4. Click OK to proceed to the customization of your installation.
Section 2. Customizing the installation
Language Selection
Select the language you prefer for the installation, then click OK to continue.
Keyboard Selection
Your HP server comes with a Generic 104-key PC keyboard.
After selecting the appropriate option for the keyboard layout type, click OK to continue.
Mouse Selection
After selecting the appropriate option for the mouse type, click OK to continue.
Disk Partitioning Setup
HP recommends selecting the automatic partitioning mode.
1. Click Autopartition to continue.
2. Remove all system partitions, then select a hard drive.
3. Click Next to continue.
4. If a Warning dialog box appears, click Yes to continue.
5. At the Partitioning dialog box, click OK.
Boot Loader Configuration
HP recommends selecting the Use GRUB Boot Loader option.
1. Select Use GRUB Boot Loader, then click OK.
2. Review the boot option and modify it if necessary, then click OK.
3. If you prefer, set a GRUB password, then click OK.
4. Review the Boot Manager setting and modify it if necessary, then click OK.
5. Select to install the boot loader in MBR, then click OK.
Network Configuration for eth0
Review the IP setting for eth0 and verify that it fits your environment, then click OK to continue.
Network Configuration for eth1
Review the IP setting for eth1 and verify that it fits your environment, then click OK to continue.
Hostname Configuration
Enter a system hostname, then click OK to continue.
Firewall
Review the Firewall settings and modify if necessary, then click OK to continue.
Language Support
Review the Language Support setting and modify if necessary, then click OK to continue.