HP ProLiant DL165 G6 Server Maintenance and Service Guide

Diagnostic tools and Setup Utilities 95
Table 12 POST Error Message
Error-Code Error Message Description / Corrective Action
Microcode Error BIOS could not find or load the CPU
Microcode Update to the CPU. The message
is most likely to appear when a new CPU is
installed in a system board with outdated
BIOS. In this situation, you must update the
BIOS to include the Microcode Update for the
new CPU.
Checking NVRAM Update Failed BIOS could not write to the NVRAM block.
This message appears when the FLASH part is
malfunctioning.
Operating system not found Operating system can not be located on any
of the boot drives
Verify that the priority boot drive has power
and that the IDE cable is connected properly.
Verify that the desired boot drive has power.
Verify that the IDE cable is securely plugged
into the respective system board connectors.
Verify that the boot device is enabled in the
Setup Utility.
Verify that the boot device has an operating
system installed.
If the problem persists, contact your HP
Customer Support provider.
60F Fan Solution Not Sufficient!
Critical Failure Detected – System Shutting
Down in 15 Seconds!
The non-redundancy fan is not installed, user
should install the system fan. The system will
shut down.
601 BMC Not Responding BMC not responding, you can load the
optimal default value, or you must change the
LO100 card.
603 System Fan 1 Missing System fan 1 is not installed, user should
install the system fan 1.
604 System Fan 2 Missing System fan 2 is not installed, user should
install the system fan 2.
605 System Fan 3 Missing System fan 3 is not installed, user should
install the system fan 3.
606 System Fan 4 Missing System fan 4 is not installed, user should
install the system fan 4.
607 System Fan 5 Missing System fan 5 is not installed, user should
install the system fan 5.
608 System Fan 6 Missing System fan 6 is not installed, user should
install the system fan 6.
610 Temperature violation Detected Wait 5 minutes for system to cool.
Press ESC key is not recommended as system
may shutdown unexpectedly.