HP ProLiant DL165 G6 Server Maintenance and Service Guide

Diagnostic tools and Setup Utilities 94
Table 12 POST Error Message
Error-Code Error Message Description / Corrective Action
048 Password check failed Password is incorrect after retried a few times.
Users might need to reset the password.
04C Keyboard/Interface Error Keyboard controller failed test. This may
indicate a problem with system hardware.
04D Primary Master Hard Disk Error The IDE/ATAPI device configured as Primary
Master could not be properly initialized by the
BIOS. This message is typically displayed
when the BIOS is trying to detect and
configure IDE/ATAPI devices in POST.
04E Primary Slave Hard Disk Error The IDE/ATAPI device configured as Primary
Slave could not be properly initialized by the
BIOS. This message is typically displayed
when the BIOS is trying to detect and
configure IDE/ATAPI devices in POST.
04F Secondary Master Hard Disk Error The IDE/ATAPI device configured as
Secondary Master could not be properly
initialized by the BIOS. This message is
typically displayed when the BIOS is trying to
detect and configure IDE/ATAPI devices in
POST.
050 Secondary Slave Hard Disk Error The IDE/ATAPI device configured as
Secondary Slave could not be properly
initialized by the BIOS. This message is
typically displayed when the BIOS is trying to
detect and configure IDE/ATAPI devices in
POST.
051 Master Hard Disk Error The IDE/ATAPI device configured as Master in
the 3rd IDE controller could not be properly
initialized by the BIOS. This message is
typically displayed when the BIOS is trying to
detect and configure IDE/ATAPI devices in
POST.
052 Master Slave Disk Error The IDE/ATAPI device configured as Slave in
the 3rd IDE controller could not be properly
initialized by the BIOS. This message is
typically displayed When the BIOS is trying to
detect and configure IDE/ATAPI devices in
POST.
202 CPU mismatch detected You should use the CPU of same frequency.
203 Unsupported processor You should change another type of processor.
Uncorrectable memory error System halts after displaying this message. If
the problem persists, contact HP Customer
Support.