HP ProLiant DL165 G6 Server Maintenance and Service Guide

Removal and Replacement Procedures 74
Figure 65 Installing the system board
Power Supply Unit (PSU)
Located on the rear panel of the server power supply is a standard autoranging 500-watt non-hot-plug
PSU.
Figure 66 Non-hot-plug Power Supply Unit
WARNING: Take note of the following reminders to reduce the risk of personal injury from electric
shock hazards and/or damage to the equipment.
•
Installation of power supply units should be referred to individuals who are qualified to service server
systems and are trained to deal with equipment capable of generating hazardous energy levels.
• DO NOT open the power supply unit. There are no serviceable parts inside it.
To remove the non-hot-plug power supply:
1. Loosen the screws that secure the non-hot-plug power supply to the chassis.
2. Lift the non-hot-plug power supply from the chassis.