HP ProLiant DL165 G5p Server Software Configuration User Guide

Server management 59
To revert to using DHCP to set the IP address, type set oemhp_dhcp_enable=TRUE to enable
DHCP.The system takes a few seconds to set the new IP address.
1. Open a browser and enter the IP address that you set manually or that was set automatically
using DHCP.
2. When prompted, enter the same user name and password you used in your terminal session.
3. Browse the server settings using the user interface that displays.
To enable console redirection via the Setup Utility:
1. In the Serial Port Configuration submenu, set the Serial port Mode field to BMC. See the “Serial
Port Configuration submenu” section for more information.
2. In the Remote access Configuration submenu, set the Com Port Address to On Board Com Port
A. See the “Remote Access Configuration submenu fields” section for more information.
3. Press F10 to Save and Exit.