HP ProLiant DL160se G6 Server Software Configuration Guide

Server management 41
Server management
Pre- and post-installation procedures
Pre-installation procedures
WARNING: Failure to properly turn off the server before you open the server or before you start
removing or installing hardware components may cause serious damage as well as bodily harm.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the chassis and any
installed hardware components to cool before touching them.
CAUTION: Follow the ESD precautions listed in Chapter 2 of the HP ProLiant DL160se G6 Server
Maintenance and Service Guide when handling any hardware component.
1. Turn off the server and all the peripherals connected to it.
2. Disconnect the AC power cord from the power supply cable located on the server rear panel to
turn off the service processor and reduce the risk of electrical shock.
3. Remove the top cover from the chassis:
a. Loosen the screw on the top cover with a T-10 wrench.
b. Press the latch on the top cover.
c. Slide the cover toward the rear of the server, and then lift the cover away from the chassis.
Figure 19 Removing the top cover
4. Place the top cover in a safe place for reinstallation later.