HP ProLiant DL160se G6 Server Software Configuration Guide

System BIOS configuration 37
Table 20
POST Error Messages
Error code Description
120 $A0CCMOS Cleared by Jumper. Restore the Jumper and Continue…
122 $A0CPassword Cleared By Jumper. Restore the Jumper and Continue…
601 Error: BMC Not Responding
605 BMC Has Detected Fatal Hardware Error
611 Internal User Area Of BMC FRU Corrupted
612 Controller Update 'boot block' Firmware Corrupted
613 Controller Operational Firmware Corrupted
624 Power Supply Failure or Power Supply Unplugged
622 Either Fan Failure or Fan Missing
194 CPUID, Processor family are different
192 L3 cache size mismatch
197 Processor speeds mismatched
POST-related troubleshooting
Perform the following procedures when POST fails to run, error messages are displayed.
If the POST failure is during a routine boot up, verify the following conditions:
• All external cables and power cables are firmly plugged in.
• The power outlet to which the server is connected is working.
• The server and monitor are both turned on. The bicolor power status LED indicator on the ear
must be green.
• The monitor's contrast and brightness settings are correct.
• All internal cables are properly connected and all boards firmly seated.
• The processor is fully seated in its socket on the system board.
• The heat sink assembly is properly installed on top of the processor.
• All memory modules are properly installed.
• If you have installed a PCI accessory board, verify that the board is firmly seated and any
jumpers on the board are properly set. Refer to the documentation provided with the accessory
board.
• All internal cabling and connections are in their proper order.
• If you have changed the jumper on the system board, verify that each is properly set.
If the POST failure occurs after installing an accessory, perform the following steps:
1. Perform the pre-installation procedure described on page 41.
2. If necessary, remove any expansion boards, assemblies, or cables that prevent access to the
system components.
3. Check the following conditions: