ProLiant DL145 Server Maintenance and Service Guide

Removal and Replacement Procedures
Processor Power Module (PPM)
To remove a PPM:
1. Power down the server. Refer to “Powering Down the Server” ea rlier in this chapter.
2. Extend the server from the rack. Refer to “Extending the Server from the Rack” earlier in
this chapter.
3. Remove the access panel. Refer to “R emoving the Access Panel” earlier in this chapter.
4. Remove the PPM.
Figure 2-8: Removing a PPM
Reverse the steps to replace a PPM.
HP ProLiant DL145 Server Maintenance and Service Guide 2-11