ProLiant DL145 Generation 3 Server Maintenance and Service Guide

Removal and replacement procedures 47
Figure 54 Removing the full-sized riser board assembly slot cover
Figure 55 Removing the low-profile riser board assembly slot cover
3. If an expansion board is installed in the assembly, perform the procedure in the “Removing an expansion
board” section on page 46.
4. Remove the expansion board from its protective packaging, handling it by the edges.
5. Verify that the size of the expansion board and its connector are compatible with the assembly.
If necessary, perform the procedures in the “Removing a riser board” section on page 44 and the
“Installing a riser board” section on page 45 to install the correct riser board.
6. Slide the expansion board into the riser board slot.
Press the board firmly to seat it properly in the slot.