ProLiant DL145 Generation 3 Server Maintenance and Service Guide

Removal and replacement procedures 44
Figure 48 Installing the full-sized assembly
Figure 49 Installing the low-profile assembly
2. Perform the post-installation procedures described on page 12.
Removing a riser board
1. Perform the procedure described in the “Removing a riser board assembly” section on page 42 to remove
the appropriate assembly.
2. If an expansion board is installed in the assembly, perform the procedure in the “Removing an expansion
board” section on page 46.
3. Remove the installed riser board from the assembly:
NOTE: Keep the two screws you remove in this step for installing the new riser board later.
a. Remove the two screws securing the riser board to the assembly.
b. Remove the riser board from the assembly.