ProLiant DL145 Generation 3 Server Maintenance and Service Guide

Removal and replacement procedures 21
Figure 14 Pre-installed screw locations in the non-hot-plug HDD carrier
• Hard drives installed in the server are labeled as drive 1 and drive 2 from left to right when viewed from
the front of the server.
Figure 15 HDD bay locations
Removing a non-hot-plug SATA hard drive
If you intend to replace a non-hot-plug SATA hard drive with another non-hot-plug SATA hard drive, use the HDD
carrier and screws you remove from the old drive to install the new drive.
To remove a non-hot-plug SATA hard drive:
1. Perform the pre-installation procedures described on page 11.
2. Disconnect the data and power cables from the rear of the hard drive.
3. Remove the HDD carrier from the chassis:
a. Loosen the screw that secures the HDD carrier to the chassis.
b. Push the HDD carrier toward the front of the chassis, then slide it out completely.