ProLiant DL145 Generation 3 Server Maintenance and Service Guide

Removal and replacement procedures 13
Figure 3 Removing the top cover
3. Place the top cover in a safe place for reinstallation later.
To reinstall the top cover:
1. Perform steps 1 to 3 of the post-installation procedures described on page 12.
2. Reinstall the top cover:
a. Place the cover on the chassis approximately 1.25 cm (0.5 in) toward the rear of the unit, then slide the
cover forward into place.
b. Tighten the captive screw on the rear panel.
To tighten the screw, HP recommends using the L-shaped wrench that ships with the server.
Figure 4 Reinstalling the top cover
3. Perform steps 5 and 6 of the post-installation procedure on page 12.