HP ProLiant DL145 Generation 3 Server Software Configuration Guide

NOS installation 41
4. Review the Boot Manager setting and modify it if necessary, then click OK.
5. Select to install the boot loader in MBR, then click OK.
Network Configuration for eth0
Review the IP setting for eth0 and verify that it fits your environment, then click OK to continue.
Network Configuration for eth1
Review the IP setting for eth1 and verify that it fits your environment, then click OK to continue.
Hostname Configuration
Enter a system hostname, then click OK to continue.
Firewall
Review the Firewall settings and modify if necessary, then click OK to continue.
Language Support
Review the Language Support setting and modify if necessary, then click OK to continue.
Time Zone Selection
Review the Time Zone Selection setting and modify if necessary, then click OK to continue.
Root Password
Enter a root password consisting of at least six alphanumeric characters, then click OK to continue.
Package Defaults
Review the software selection and modify it as necessary, then click OK to continue.
Package Group Selection
Review and modify the selection as necessary, then click OK to continue.
If you selected the Custom install option, pre-determined packages have already been selected. However,
depending upon your network environment additional packages may be necessary.
NOTE: Remember to select the appropriate package groups that match your network settings. For example, the
DNS Name Server package may be required if you have set up your new server to be the DNS controller.
Section 3. Installing Red Hat Enterprise Linux 3
Installation to Begin
Once you complete the customization, the installation program asks for confirmation before proceeding with the
install. Click OK to proceed.
You may be prompted to insert the rest of the RHEL3 CD-ROMs, depending on the packages you have chosen to
install.
Video Card Configuration
Select the Matrox G200e option from the list of video hardware, then click OK to continue.
Monitor Configuration
The installation program attempts to detect the monitor being used; otherwise, you can find HP monitor
references on the back of your monitor. Click OK to continue.
X Customization
Select Text for the default login option, then click OK to continue to the final page. Click OK again to complete
the installation.
After completing the installation, click OK to close the installation program. The system reboots and loads your
new Red Hat environment.