HP ProLiant DL145 Generation 3 Server Software Configuration Guide

System BIOS configuration 26
Error message 1 of 1: Error code 0103
Keyboard not detected - Keyboard error
In some cases an error message may include recommendations for troubleshooting or require that you press the
Enter key to display recommendations. Follow the instructions on the screen.
Table 17 lists the most common POST error messages with their corresponding troubleshooting recommendation.
It is recommended that you correct the error before proceeding, even if the server appears to boot successfully.
If your system displays one of the messages marked below with an asterisk (*), write down the code and
message and contact your HP Customer Support provider.
When no POST error message is displayed but the server stops during POST, listen for beep codes.
Table 17 POST Error Messages
Error code Error message Description/corrective action
0200 Failure Fixed Disk Fixed disk is not working or not configured properly.
1 Run Setup and check if the fixed-disk type is correctly identified.
2 Check to see if fixed disk is attached properly.
0210 Stuck key Stuck key on keyboard.
1 Locate the stuck key on your keyboard and release it.
2 Reboot the server.
0211 Keyboard error Keyboard not working.
Verify that the keyboard cable is securely connected to the keyboard
port (not the mouse port) on the rear panel of the server.
If the problem persists, replace the keyboard or contact your HP
Customer Support provider.
0212 Keyboard Controller Failed Keyboard controller failed test.
0220 Monitor type does not match CMOS -
Run SETUP
The attached monitor cannot be correctly identified by Setup.
Run Setup and check if the monitor type is correctly identified.
0250 System battery is dead - Replace and run
SETUP
The CMOS clock battery indicator shows the system battery is dead.
1 Replace the system battery following the procedures in the HP
ProLiant DL145 Generation 3 Server Maintenance and Service
Guide.
2 Run Setup to reconfigure the system.
0251 System CMOS checksum bad - Default
configuration used
The settings in the Setup Utility have been corrupted or modified
incorrectly, perhaps by an application program that changes data
stored in CMOS.
You can either:
• Load the system default values following the procedures on
page 25.
• Access Setup and enter your own custom values.
If the error persists, check the system battery or contact your HP
Customer Support provider.
0260 System timer error The timer test failed. Requires repair of the system board.
0270 Real time clock error Real-Time Clock (RTC) fails BIOS hardware test. May require board
repair.
0271 Check date and time settings BIOS found date or time out of range and reset the RTC. May
require setting legal date (1991-2099).
Access Setup and check the values in the System Time and System
Date fields of the Main menu.
0280 Previous boot incomplete – Default
configuration used
Initial bootup failed. BIOS automatically loads the default system
values, then boot again.
0281 Memory size found by POST differed
from CMOS
The user has added or removed a memory module, thus a memory
size that is different from the previous bootup.
02F5 DMA test failed The DMA control test failed.
02F6 Software NMI failed An NMI signal is detected and/or a user has pressed the NMI
switch.