HP ProLiant DL140 Server Maintenance and Service Guide

HP ProLiant DL140 Server Maintenance and Service Guide 24
Front USB Cable
To remove the Front USB cable:
1. Power down the server. See “Powering Down the Server” in this chapter.
2. Remove the top cover. See “Top Cover” in this chapter.
3. Remove the PCI riser board assembly. See “PCI Riser Board Assembly” in this chapter.
4. Remove the fan bracket. See “Fan Bracket” in this chapter.
5. Remove the optical CD-ROM drive assembly; see “Optical CD-ROM Drive Assembly” in
this chapter.
6. Remove the hard drive tray(s), See “Hard Drive” in this chapter.
7. Disconnect the USB cable from the system board (1).
Remove the USB Cable from the front of the chassis (2) using a flat blade screwdriver to depress
plastic tabs (top and bottom of connecters).
NOTE: The top tabs can be accessed once the CD-ROM Drive assembly is removed. The
bottom tabs can be accessed from the bottom of the server.
Figure 2-16: Remove the front USB cable.
Reverse steps 1 through 7 to replace the optical device assembly cable.