ProLiant DL140 Generation 2 Server Maintenance and Service Guide

Removal and replacement procedures 11
This symbol indicates the presence of electric shock hazards. The area contains no user or field serviceable
parts. Do not open for any reason.
WARNING! To reduce the risk of injury from electric shock hazards, do not open this enclosure
This symbol on an RJ-45 receptacle indicates a network interface connection.
WARNING! To reduce the risk of electric shock, fire, or damage to the equipment, do not plug telephone or
telecommunications connectors into this receptacle.
This symbol indicates the presence of a hot surface or hot component. If this surface is contacted, the potential
for injury exists.
WARNING! To reduce the risk of injury from a hot component, allow the surface to cool before touching.
These symbols, on power supplies or systems, indicate that the equipment is supplied by multiple sources
of power.
WARNING! To reduce the risk of injury from electric shock, remove all power cords to completely
disconnect power from the system.
Weight in kg
Weight in lb
This symbol indicates that the component exceeds the recommended weight for one individual to handle
safely.
WARNING! To reduce the risk of personal injury or damage to the equipment, observe local
occupational health and safety requirements and guidelines for manual material handling.
Rack warnings
WARNING! To reduce the risk of personal injury or damage to equipment, always ensure that the rack is
adequately stabilized before extending a component outside the rack. A rack may become unstable if more
than one component is extended for any reason. Extend only one component at a time.
WARNING! To reduce the risk of personal injury or damage to the equipment, be sure that:
•
The leveling jacks are extended to the floor.
• The full weight of the rack rests on the leveling jacks.
• The stabilizers are attached to the rack, if it is a single rack installation.
• The racks are coupled together in multiple rack installations.
WARNING! When installing the server in a Telco rack, make certain that the rack frame is adequately secured
to the building structure at the top and bottom.
WARNING! To reduce the risk of personal injury or damage to the equipment, at least two people are needed
to safely unload the rack from the pallet. An empty 42U rack weighs 115 kg (253 lb), is over 2.1 m (7 ft) tall,
and may become unstable when being moved on its casters. Do not stand in front of the rack as it rolls down
the ramp from the pallet. Handle the rack from both sides.
CAUTION: This ProLiant server is intended for rack-mount operation. The server bezel is made from glossy
material. For safety purposes, do not place the server in the visual field of users to prevent any accidents
arising from light bouncing off the bezel’s surface.
ACHTUNG: Entsprechend der Bildschirmabeitsplatzverordnung, darf das Gerät nicht im Gesichtsfeld des
Bedieners aufgestellt werden, da das Gehäuse eine glänzende Front aufweist.