HP ProLiant BL685c Server Blade Installation Instructions

4. Push the device bay shelf back unti
l it stops, lift the right side
slightly to disengage the two tabs from the divider wall, and
then rotate the right edge
downward (clockwise).
5.
Lift the left side of the device bay shelf to disengage the three
tabs from the divider wall, and then remove it from the
enclosure.
6.
Remove the connector covers.
7. Prepare the server blade for installation.
8.
Install the server blade.
CAUTION:
To prevent improper cooling and thermal
damage, do not operate the se rver blade or the enclosure
unless all hard drive and device bays are populated with
either a component or a blank.
9. Locate the coupler plate that ships with each full-height device.
10. Use the coupler plate to join tw
o half-height device bay blanks
to form a full-height device bay blank:
a. Install the coupler plate on top of the blank, and then slide
the coupler plate forward until it locks into place.
b. Install the second blank onto the tabs on the coupler plate,
and then slide the second bl
ank back until it locks into
place.
11.
Install the full-height blank into the device bay.
Completing the configuration
To complete the server blade and HP BladeSystem configurati
on, see
the overview card that ships with the enclosure.