HP ProLiant BL660c Gen8 Server Blade Maintenance and Service Guide

Removal and replacement procedures 51
To replace the component:
1. Install the server blade release lever.
2. Align the system board, and then slide it into place inside the base pan.
IMPORTANT: Install all components in the same configuration prior to removing the system
board.
3. Install the front panel/drive cage assembly ("Front panel/drive cage assembly" on page 37).
4. Connect all cables to the hard drive backplane. For more information, see "Cabling (on page 64)."
5. Install all DIMMs ("DIMMs" on page 29).
6. Install all DIMM baffles ("DIMM baffles" on page 27).
7. Install and route the cables for all capacitor packs. For more information on routing the cables, see
"FBWC capacitor pack cabling (on page 64)."
8. Install the hard drives ("Drive" on page 25).
9. Install the hard drive blanks ("Drive blank" on page 25).