HP ProLiant BL660c Gen8 Server Blade Maintenance and Service Guide

Removal and replacement procedures 37
Front panel/drive cage assembly
To remove the component:
1. Power down the server blade (on page 22).
2. Remove the server blade (on page 23).
3. Remove the access panel ("Access panel" on page 24).
4. Remove all drives ("Drive" on page 25).
5. Remove all DIMM baffles ("DIMM baffles" on page 27).
6. Remove all FBWC capacitor packs ("Removing the FBWC capacitor packs" on page 35).
7. Disconnect the two signal cables and one power cable from each SAS backplane.
8. Extend the serial label pull tab.
9. Remove the front panel/drive cage assembly.
To replace the component, reverse the removal procedure.