HP ProLiant BL660c Gen8 Server Blade Maintenance and Service Guide

Removal and replacement procedures 30
7.
Remove the DIMM and then use the DIMM tool to close the DIMM slot.
To replace the component:
1. Use the DIMM tool to open the DIMM slot.
2. Install the DIMM.
3. Install all DIMM baffles ("DIMM baffles" on page 27).
4. Attach the FBWC capacitor pack cabling (on page 64), if necessary.
5. Install the access panel ("Access panel" on page 24).
6. To configure the memory mode, use RBSU ("HP ROM-Based Setup Utility" on page 53).
Mezzanine assembly
To remove the component:
1. Power down the server blade (on page 22).