HP ProLiant BL490c G7 Server Blade Maintenance and Service Guide

Removal and replacement procedures 40
6.
Apply all the grease to the top of the processor in the following pattern to ensure even distribution.
CAUTION: To avoid possible thermal damage, install replacement heatsinks as indicated on the
heatsink labels. The heatsinks are not interchangeable between processor 1 and processor 2
within a server blade.
7. Install the heatsink. Insert both screws, and then alternate tightening until the heatsink is seated properly.
8. Install the DIMM baffle ("DIMM baffle" on page 25).
9. Connect the hard drive cables ("Hard drive cabling" on page 59).
10. Install the access panel ("Access panel" on page 24).
11. Install the server blade.
System board
To remove the component:
1. Power down the server blade (on page 22).
2. Remove the server blade (on page 23).
3. Remove the access panel ("Access panel" on page 24).
4. Remove all hard drives ("Hard drive" on page 24).
5. Remove the DIMM baffle ("DIMM baffle" on page 25).