HP ProLiant BL490c G7 Server Blade Maintenance and Service Guide

Removal and replacement procedures 31
Release button
To remove the component:
1. Power down the server blade (on page 22).
2. Remove the server blade (on page 23).
3. Remove the access panel ("Access panel" on page 24).
4. Remove the front bezel ("Front bezel" on page 28).
5. Open the server blade release lever.
6. Remove the release button.
To replace the component, reverse the removal procedure.
Heatsink blank
To remove the component:
1. Power down the server blade (on page 22).
2. Remove the server blade (on page 23).
3. Remove the access panel ("Access panel" on page 24).
4. If installed, disconnect the hard drive power and data cables from the system board.
5. Remove the DIMM baffle ("DIMM baffle" on page 25).