HP ProLiant BL465c Gen8 Server Blade Maintenance and Service Guide

Removal and replacement procedures 57
12.
Slide the system board approximately 1.27 cm (0.50 inches) towards the rear of the server, and then
lift the system board from the base pan.
13. Remove the three T-10 screws from the outside of the base pan, and then remove the server blade
release lever bracket.
14. Remove the T-10 screw from the inside of the base pan and then remove the server blade release lever
assembly.
To replace the component:
1. Install the server blade release lever assembly, and then install the T-10 screws from the outside of the
base pan.