HP ProLiant BL465c Gen8 Server Blade Maintenance and Service Guide

Removal and replacement procedures 40

Remove the front panel/drive cage assembly.

To replace the component, reverse the removal procedure.

Heatsink blank

To remove the component:

1. Power down the server blade (on page 22).

2. Remove the server blade (on page 23).

3. Remove the access panel ("Access panel" on page 24).

CAUTION: Always disconnect the drive cables from the SAS controller before removing the

DIMM baffle. Failure to do so may result in damage to the SAS controller.

4. Disconnect the drive cables from the SAS controller and remove the DIMM baffle ("DIMM baffle" on

page 27).

5. Remove all hard drives ("Drive" on page 25).

6. Remove the front panel/hard drive cage assembly ("Front panel/drive cage assembly" on page 39).