HP ProLiant BladeSystem p-Class System Maintenance and Service Guide

Diagnostic Tools 67
Figure 3-4 Set Enclosure Serial Number screen
To set the enclosure serial number:
1. Type the new serial number.
2. Press the Enter key.
3. Type the new serial number again.
4. Reset all management modules in the rack for the changes to take effect.
Power Management Module
This section describes diagnostic screens for the power management module.
IMPORTANT: The screens in this section only provide information about the power enclosure to which you are
connected. To run diagnostics and access information about different power enclosures, you must connect to
the power management module on that enclosure.
NOTE: When accessing the infrastructure diagnostics on a powered module, the screen may be blank or it
may display information from the previous diagnostic cycle. Refresh the screen to see current data.
Power Supply Status Screen
Figure 3-5 Power Supply Status screen (power management module)
The Power Supply Status screen includes the following information:
• Uptime
• Power supply location (slot #), status, power usage, input/output temperature
• Enclosure backplane temperature