HP ProLiant BL420c Gen8 Server Blade MSG

Removal and replacement procedures 59
12.
Install the hard drives ("Drive" on page 25).
13. Install the hard drive blanks ("Drive blank" on page 25).
14. Install the access panel ("Access panel" on page 24).
Serial label pull tab
To remove the component:
1. Power down the server blade (on page 22).
2. Remove the server blade (on page 23).
3. Remove the access panel ("Access panel" on page 24).
4. Remove all hard drives ("Drive" on page 25).
5. Remove all hard drive blanks ("Drive blank" on page 25).
6. Disconnect the capacitor pack cabling, if connected ("FBWC capacitor pack cabling" on page 65).
7. Remove the SAS controller ("SAS controller" on page 27).
8. Remove all DIMM baffles ("DIMM baffles" on page 28).
9. Remove all DIMMs ("DIMMs" on page 30).
10. Remove the heatsink blank, if installed ("Heatsink blank" on page 31).
11. Remove the front panel/hard drive cage assembly ("Front panel/drive cage assembly" on page 43).
12. While holding the system board in place, turn the base pan on its side and remove the two system
board screws from the bottom of the base pan.
13. Place the server blade on a flat, level surface.