ProLiant BL40p Server Blade Maintenance and Service Guide

Removal and Replacement Procedures
Power Modules
The ProLiant BL40p server blade has two system board power modules and one PCI-X
mezzanine power module. Refer to Figure 4-3 and Table 4-2 for locations. To remove a
power module:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
“Server Blad e Preparation” section in this chapter.
2. Remove the access panel. Refer to the “ Access Panel” section in this chapter.
3. Pull out the power module latches (1), and remove the power module from the slot (2).
Figure 2-18: Removing a power module
HP ProLiant BL40p Server Blade Maintenance and Service Guide 2-19