ProLiant BL40p Server Blade Maintenance and Service Guide

Removal and Replacement Procedures
Access Panel
To remove the access panel:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
“Server Blad e Preparation” section in this chapter.
2. Lift up on the hood latch handle until the access panel disengages from the chassis (1).
3. Slide the access panel about 1.3 cm (0.5 in) toward the rear of the unit and lift the panel
to remove it (2).
Figure 2-5: Removing the server blade access panel
Reverse steps 1 through 3 to replace the access panel.
2-8 HP ProLiant BL40p Server Blade Maintenance and Service Guide