HP ProLiant BL40p Server Blade Maintenance and Service Guide

Removal and Replacement Procedures
Power Button/LED Board
To remove the power button/LED board:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
“Server Blade Preparation” section in this chapter.
2. Remove the access panel and the system board tray assembly. Refer to the “Server Blade
Preparation” section in this chapter.
3. Use a Torx-15 screwdriver to remove the two retaining screws from the power
button/LED board (1).
4. Lift the power button/LED board off the chassis (2).
Figure 2-33: Removing the power button/LED board
Reverse steps 1 through 4 to replace the power button/LED board.
HP ProLiant BL40p Server Blade Maintenance and Service Guide 2-33