HP ProLiant BL40p Server Blade Maintenance and Service Guide

Removal and Replacement Procedures
Ethernet Passthrough Board
To remove the Ethernet passthrough board:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
“Server Blade Preparation” section in this chapter.
2. Remove the access panel. Refer to the “Access Panel” section in this chapter.
3. Disconnect RJ-45 cables from either the PCI-X mezzanine board or the Ethernet
passthrough board.
4. Turn the thumbscrew to release the Ethernet passthrough board (1) and pull the board out
of the chassis (2).
Figure 2-28: Removing the Ethernet passthrough board
Reverse steps 1 through 4 to replace the Ethernet passthrough board.
2-28 HP ProLiant BL40p Server Blade Maintenance and Service Guide