HP ProIiant BL2x220c G6 Server Blade Maintenance and Serivce Guide

Removal and replacement procedures 45
Warning: The serial number should ONLY be modified by qualified personnel.
This value should always match the serial number located on the chassis.
5. Press the Enter key to clear the warning.
6. Enter the serial number and press the Enter key.
7. Select Product ID. The following warning appears:
Warning: The Product ID should ONLY be modified by qualified personnel. This
value should always match the Product ID on the chassis.
8. Enter the product ID and press the Enter key.
9. Press the Esc key to close the menu.
10. Press the Esc key to exit RBSU.
11. Press the F10 key to confirm exiting RBSU. The server blade automatically reboots.
Server B system board
To remove the component:
1. Power down the server blade (on page 22).
2. Remove the server blade (on page 23).
3. Access the internal server components (on page 24).
4. If installed, remove the server B USB key or SD card adapter (on page 28).
5. Remove the serial label pull tab.
6. If installed, remove the hard drive (on page 25).
7. Remove all DIMMs ("DIMMs" on page 27).
8. Remove the heatsink ("Heatsink" on page 29).