HP ProLiant BL280c G6 Server Blade Maintenance and Service Guide

Removal and replacement procedures 46
4. If installed, disconnect the hard drive power and data cables from the system board ("Hard drive
connector identification" on page 66).
5. Remove the air baffle ("Air baffle" on page 25).
6. Remove all mezzanine cards ("Mezzanine card" on page 34).
7. Remove the USB/SD card module ("USB/SD card module" on page 35).
8. Remove all DIMMs ("DIMMs" on page 28).
9. Remove the heatsink ("Heatsink" on page 37).
10. Open the processor locking lever and the processor socket retaining bracket.
11. Using the processor tool, remove the processor from the system board:
a. Line up the processor tool, ensuring the locking lever graphic on the tool is oriented correctly.
b. Press in on the plastic tabs, and then place the tool on the processor.
c. Release the tabs, and then carefully lift the processor and tool straight up.