HP ProLiant BL280c G6 Server Blade Maintenance and Service Guide

Removal and replacement procedures 32
4. Route the cables through the air baffle.
5. Install the air baffle ("Air baffle" on page 25).
6. Connect hard drive data cable 1 to SATA connector 1 on the system board.
7. Connect hard drive data cable 2 to SATA connector 2 on the system board.
8. Connect the hard drive power cables to the hard drive power connectors on the system board. The
power cables can connect to either of the hard drive power connectors on the system board.
9. Install the access panel ("Access panel" on page 25).
10. Install the server blade.
Server blade release lever
To remove the component:
1. Power down the server blade (on page 23).
2. Remove the server blade (on page 24).