HP ProLiant BL280c G6 Server Blade Maintenance and Service Guide

Removal and replacement procedures 25
3. Remove the server blade.
4. Place the server blade on a flat, level work surface.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server blade
before beginning any installation procedure. Improper grounding can cause ESD.
Access panel
To remove the component:
1. Power down the server blade (on page 23).
2. Remove the server blade (on page 24).
3. Press the access panel release button.
4. Slide the access panel towards the rear of the server blade, and then lift to remove the panel.
To replace the component:
1. Place the access panel on top of the server blade.
2. Slide the access panel forward until it clicks into place.
Air baffle
To remove the component:
1. Power down the server blade (on page 23).
2. Remove the server blade (on page 24).
3. Remove the access panel ("Access panel" on page 25).
4. If installed, disconnect the hard drive power and data cables from the system board ("Hard drive
connector identification" on page 66).