ProLiant BL e-Class C-GbE Interconnect Switch Web-based Interface Reference Guide

Configuring the Switch Modules using the Web-based Interface
Configuring Priority MAC Addresses
To set the priority level for a MAC address:
1. Select Priority MAC Address from the Configuration menu. The following screens are
displayed.
2. Type the VLAN ID in the VLAN ID field.
3. Type the MAC address for which priority on the switch module is to be established in the
MAC Address field.
4. Type the priority level for the MAC address in the Priority Level field. The range is
from 0 to 7, with 0 being the highest priority.
5. In the Look at field, select the state under which the priority will be active. The
options are:
— Dst. Addr—Packets with the selected MAC address as their destination will be given
the selected priority.
— Src. Addr—Packets with the selected MAC address as their source will be given the
selected priority.
— Either—All packets with the selected MAC address will be given the selected
priority.
6. Click Apply to apply the changes.
IMPORTANT: To save the configuration settings permanently, you must enter them into NVRAM
using the Save Changes option on the Maintenance menu. Refer to the section, “Saving
Changes,” earlier in this chapter.
HP ProLiant BL e-Class C-GbE Interconnect Switch Web-based Interface Reference Guide 2-37