ProLiant BL e-Class C-GbE Interconnect Switch Web-based Interface Reference Guide

2
Configuring the Switch Modules using the Web-based
Interface
Overview
This chapter describes how to configure the switch modules from the Web-based interface
Saving Changes
The switch module has two types of memory: dynamic RAM and non-volatile RAM
(NVRAM). Restarting the switch module erases all configuration settings in RAM and
reloads the stored settings from NVRAM. Thus, it is necessary to save all configuration
setting changes to NVRAM before rebooting the switch module.
After the configuration settings have been saved to NVRAM, they become the current
runtime settings for the switch module. These settings are then used every time the switch
module is rebooted.
Configuration changes on a screen are made effective by clicking Apply. The settings are
then immediately applied to the switching software in RAM.
To make your configuration changes permanent, save them to NVRAM using the Save
Changes option on the Maintenance menu before rebooting the system.
HP ProLiant BL e-Class C-GbE Interconnect Switch Web-based Interface Reference Guide 2-1