ProLiant BL e-Class C-GbE Interconnect Switch Command Line Interface Reference Guide

2
Configuring the Switch Modules using the Command
Line Interface
Overview
This chapter describes how to configure the switch modules from the command line
interface (CLI).
Saving Changes
The switch module has two types of memory: dynamic RAM and non-volatile RAM
(NVRAM).
Restarting the switch module erases all configuration settings in RAM and reloads the stored
settings from NVRAM. Thus, it is necessary to save all configuration setting changes to
NVRAM before rebooting the switch module.
After the configuration settings have been saved to NVRAM, they become the current
runtime settings for the switch module. These settings are then used every time the switch
module is rebooted.
Use the following command to retain any configuration changes permanently in NVRAM:
Command Description
cfg save
Saves current configuration settings to the switch NVRAM
IMPORTANT: After saving your final configuration, HP highly recommends that you save the
configuration image to TFTP server storage. Refer to the “Initiating a TFTP Upload for Log File or
Configuration File” section later in this chapter for more information.
Use the following command to display the current configuration settings:
Command Description
cfg show
Displays current configuration settings
HP ProLiant BL e-Class C-GbE Interconnect Switch Command Line Interface Reference Guide 2-1