ProLiant BL e-Class C-GbE Interconnect Switch Command Line Interface Reference Guide

Configuring the Switch Modules using the Command Line Interface
HP ProLiant BL e-Class C-GbE Interconnect Switch Command Line Interface Reference Guide 2-87
Performing a Ping Test
Use the following command to run the ping utility:
Command Description
ping <ip_addr>
[<repeat>]
Pings the target IP address and repeats pinging
infinitely or a specified number of times
Type the target IP address in the command. To
specify the number of times to ping, type a
number from 0 to 244. Zero (0) means an
infinite number of times. The default is 1.
Press the ESC key to stop the ping.
Rebooting the Switch Module
Use the following command to reboot the switch:
Command Description
reboot
[ {cfg-save | load-def | save-ip-load-def} ]
Reboots the switch module
To save the configuration, type one of the
following in the command:
• cfg-save—Type cfg-save to save the
current configuration settings and reboot
the switch module.
• load-def—Type load-def to reboot the
switch module to the factory default
configuration settings.
• save-ip-load-def—Type save-ip-load-def
to reboot the switch module to the factory
default configuration settings. This option
allows the switch to retain its last IP
address.
Logging Out
Use the following command to exit the current CLI session:
Command Description
logout
Logs the user out of the current CLI session