HP Switch Services Modules - HP SECBLADEII-CMW520-F3171P05 Release Notes

HP SECBLADEII-CMW520-F3171P05
Release Notes
Hewlett-Packard Development Company, L.P.
53
<HP> system-view
[HP] user-interface console 0
[HP-ui-console0] authentication-mode password
[HP-ui-console0] set authentication password simple 123456
The above information indicates that the password authentication is adopted on the
console interface and that the password is set to 123456 and stored in plain text.
NOTE:
• After reboot, the SecBlade card runs the default configuration, but the original
configuration file is still kept in the CF card.
To restore the original configuration, you can
first use the display saved-configuration command to locate it and then copy and run
it.
• If the user password is stored in plain text, you can use the display current-configuration
command to view the password in the current configuration. If you use the set
authentication password cipher 123456 command to set your user password, the
password will be stored in cipher text.
Step4 Save your new user password.
[HP] save
NOTE:
• After you set a new user password, use the save command to save the password.
• You are recommended to save the new user password in the default configuration file.
BootWare password loss
Contact your local dealer or HP technical support if you forget the BootWare password of
the SecBlade card.
You can modify the BootWare password on the main menu.
Step1 Select 5 on the main menu to modify the BootWare password as prompted.
The following information is displayed:
please input old password:
Step2 Enter the old BootWare password:
please input old password: ******
NOTE:
• If you enter the old BootWare password incorrectly, “Wrong password, Please input
password again:” appears.
• After three attempts to enter the correct old BootWare password, “Wrong password,
system halt.” appears and the SecBlade card halts.
Step3 Enter a new BootWare password twice at the prompt.
Please input new password: ******
Please input new password again: ******