SuperStack 3 Advanced RPS Type 3 Power Module (3C16075) Installation Guide

Technical Information
11
CAUTION:
Do not attempt to use a ‘Y’ cable to power two separate
SuperStack 3 units. The equipment may not operate.
CAUTION:
All DC cable screws must be tightened with a suitable
tool.
Technical Information
Troubleshooting
If the LEDs on the SuperStack 3 Advanced RPS Chassis indicate a
problem refer to Table 2, which contains a list of problems and
possible faults.
If you have a problem that is not listed here and you cannot solve it,
please contact your local technical support representative.
Table 2
Problems indicated by LEDs
Mechanical
Weight 633 g (22 oz)
Size 276 x 87 x 42 mm (10.8 x 3.4
x 1.6 in.)
Electrical - Maximum Current Available
+27.0 volts 12.5 A
Power Consumption
Typical Input Power: 395 W
Total continuous output: 325 W
Problem Possible Fault
No Input LED ON
■
Mains power is not present.
■
AC power cord is incorrectly connected.
■
Power cord may be faulty.
■
LED failed. Contact your supplier.
DUA1607-5AAA02.fm Page 11 Tuesday, September 26, 2000 3:14 PM