EPS 2011-04

5-17

Installing and Connecting the HP Redundant / External Power Supplies

Installation Procedures

Connecting EPS Ports to Switches.

To co nn ect:

Push the EPS cable plug into the EPS

port until the tab on the plug clicks into

place. When power is on for the 600

RPS/EPS or HP 610 EPS and for the

connected device, the Device

Connected LED should go on to confirm

a powered-on switch is at the other end

of the cable.

If the Device Connected LED does not

go on when the EPS cable is connected

to the port, see Diagnosing with the

LEDs in chapter 5, “Troubleshooting.”

To disconnect:

Press the small tab on the plug and pull

the plug out of the port.

Refer to “EPS Port Operation” on page 1-5 for detailed information and on PoE

power usage, and to “Limitations” on page 5-31 and “Limitations (Calculating

the required number of HP 610 EPS units)” on page 5-33 for information on

maximum available PoE power.

EPS 1

EPS 2

EPS Cable:

• Only use the cables supplied with the unit

• The cable connectors are keyed and can

only be attached in one orientation